Ideal for the
6601415A and 6601415C
kits. The sockets will
fit the square and shank on the Drill, Counterbore, Tap and
Driver giving you more control of the tools.
P/n 662TSS
listed below.
The Drill size on the 6601415A
& 6601415C is .578
inches.
Your normal 1/2 drill motor will not open large enough to hold
the shank of this drill. This tap socket set is useful in vehicles
like VW, Honda, Chrysler and many others, because of
obstructions like a frame rail, it would not be possible to use
a drill motor because the angle will not be straight.
Square drive sockets will give you more control of the tools
then a standard 12 point socket because they support the
tool shanks. Using a standard 1/2
drive ratchet you can turn
the tooling by hand.
PART
# 66270940
Our tooling is supplied with square drives.
Normally you would use a
EXAMPLE
FOR M14x1.5 DRAIN
PAN KIT 12 POINT SOCKETS
1) Drill
square = 1/2 inch 12 point socket
2) Counterbore
square = 7/16 inch 12 point
socket
3) Tap
square = 7/16 inch 12 point socket
4) Driver tool
square = 3/8 inch 12 point
socket
This is only one possible solution
to turning a tool with
a square drive.
If there are no obstructions where you can use a drill motor
as in many
motorcycle and ATV applications use kit
p/n
6601415CS&D.
This kit uses a reduced shank drill for
1/2 drill motor.
Drain pan thread repair kit.
Link back to: oil drain pan repair page.